Merida Bike Manuel d'utilisateur télécharger pdf (Page 49)

Campagnolo EPS

Adjustment and maintenance

If you have bigger hands and want to position the levers

further away from the handlebars, Campagnolo offers

insert pieces which can be inserted under the Ergopower

lever unit towards the handlebars.

The gears must be readjusted after you have mounted a

new rear wheel or when shifting has become imprecise.

Shift to the biggest chainwheel (front) and into the tenth

speed, i.e. on the second smallest sprocket (rear).

Press on both Ergopower shifter units simultaneously

the mode-buttons for a little bit more than 5 seconds

(e)

. The interface control lamp at the stem changes its

color to blue. The setting mode is activated.

Press the shift lever towards the bigger sprockets. The

rear derailleur moves inward in some 1/100 mm steps.

Check whether the chain makes any noise by turning

the crank by the pedal forward and backward.

The chain moves in the opposite direction, i.e. towards

the smaller sprockets, by pressing the lever pointing to

the center of the handlebars

(f)

. As is the case with the

other lever, the rear derailleur moves the more the lon-

ger you leave your thumb on the lever. Be sure to check

the run of the chain again and again until it produces

hardly any noise any longer.

Press the mode-button of one Ergopower lever twice to

return to the cycle mode. This will be conﬁrmed by the

interface control lamp where the blue light starts to blink.

Carefully shift through the gears until the chain runs on

the biggest sprocket. If the shifting is not smooth, read-

just once again.

Continue turning the crank carefully and make sure the

rear derailleur cage does not collide with the spokes and

the chain does not move beyond the biggest sprocket.

While doing so, press your thumb against the rear de-

railleur.

If necessary, readjust at the setscrew with a 2-mm Allen

key

(g)

. By turning the setscrew clockwise you limit the

swiveling range. By turning it counterclockwise the rear

derailleur obtains a little more space towards the wheel.

Check the space between the chain guide roll and the

big sprocket. The distance should be 5 to 7 mm. Turn the

screw on the joint for adjustment

(h)

. Turning the screw

clockwise reduces the space.

To adjust the front derailleur shift to the small chain-

wheel (front) and to the biggest sprocket (rear). Activate

and adjust, as described above. Proceed, however, with

the adjustment on the left Ergopower lever. Turn the

crank forward and backward to check whether the chain

runs along the front derailleur (distance 0.5 mm) without

touching it.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Merida Bike Manuel d'utilisateur Page 49

Commentaires sur ces manuels

Produits connexes et manuels pour Bicyclettes Merida Bike