Merida Bike Manuel d'utilisateur Page 47

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 46
47
e
f
g
h
Shimano Di2
Adjustment and maintenance
If you wish, your MERIDA dealer can also change the
functioning of the Di2 control buttons
(e+f)
. The change
has to be done with a special test device from Shimano
which is also used for troubleshooting.
If you have smaller hands and want to position the le-
vers closer to the handlebars, there are special adjusting
screws on the handlebars. The handling of these screws
is described in the chapter “Adjusting the brake lever
reach on MERIDA road bikes”.
To adjust the rear derailleur shift into one of the middle
gears press the button at the front switch under the han-
dlebars until the control lamp illuminates red
(g)
. The
fine adjustment of the rear derailleur can now be carried
out. Turn the crank and listen to the noise of the chain
while running.
If there is a noise when the chain rolls off, press the front
lever. With every push the rear derailleur moves inward
by one decimillimeter. If the noise gets louder, press the
rear lever.
The rear derailleur moves outwards in steps of one deci-
millimeter. Once the chain runs quietly, press the button
at the switch once again, the red light goes out. Finish by
shifting through all the gears to check the proper func-
tioning.
Carefully shift through the gears until the chain runs on
the biggest sprocket. If the shifting is not smooth, read-
just once again.
Continue turning the crank carefully and make sure the
rear derailleur cage does not collide with the spokes and
the chain does not move beyond the biggest sprocket.
While doing so, press your thumb against the rear de-
railleur.
In principle, the limit stops are adjusted like the lim-
it stops of the mechanical gears
(h)
. Be careful when
shifting to the lowest and biggest gears in order to check
the position of the limit stops.
G
Make a test ride in a place free of traffic be-
fore you use your new Di2 gears.
I
Read the operating instructions of the gear
manufacturer on this MERIDA CD-ROM.
Vue de la page 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

Commentaires sur ces manuels

Pas de commentaire